| DIRECTIONS:
- Remove
the screw cap of the seam sealer and replace
it with the nozzle applicator tip cap.
- Cut
tip to allow application of a 1/8" bead.
Apply 1/8" continuous bead of seam adhesive
to the edge of the carpet where the face yarns
enter the backing.
- Apply
adhesive to one edge only.
- After
applying the bead, butt both edges of the
carpet together while the adhesive is still
wet (approximately 5-10 minutes)
CLEANUP:
- Wet
Adhesive: Clean,
white cloth dampened with soapy water.
- Dried
Adhesive: Clean,
white cloth dampened with mineral spirits;
carefully following warnings on the container.
WARNINGS:
Carefully read and follow all cautions and warnings
on the product label. Refer to the Material
Safety Data Sheet for additional product
information. |
