|
DIRECTIONS:
Refer to carpet
manufacturer’s specific recommendations. Condition
the area to be installed, adhesive and flooring at
65°F (18°C) or above for 48 hours before,
during and 48 hours after installation. Floor must
be sound, smooth, dry, clean and free of excessive
moisture and/or alkali. Remove dirt, wax, loose paint
and all other foreign matter that would interfere
with a good bond such as curing agents and sealers.
- Stir any liquid on
the surface into the adhesive.
- Full spread adhesive
using recommended trowel brush, short nap roller
or flat side of trowel.
- Releasable: Before
installing carpet tile or cushion, allow adhesive
to set open until dry to the touch, approximately
45-60 minutes. When dry to the touch, the adhesive
will be tacky with no transfer to fingers.
- Permanent: Before
installing carpet tile, allow adhesive to set open
until somewhat tacky but not dry to the touch. Install
cushion immediately into wet adhesive.
- Cut, fit, and reposition
flooring; HENRY 630 has unlimited working time.
- Protect carpet from
exposure to water from cleaning and other sources
for a minimum of 30 days after installation.
CLEANUP:
- Wet
Adhesive: Clean, white cloth dampened with soapy
water.
- Dried
Adhesive: Clean, white cloth dampened with mineral
spirits; carefully following warnings on the container.
WARNINGS:
Carefully read and follow all cautions and warnings
on the product label. Refer to the Material
Safety Data Sheet for additional product information.
|
