PREPARATION:

• Refer to carpet manufacturer’s specific recommendations.
• Condition the area to be installed, adhesive and flooring at 65°F (18°C)
  or above for 48 hours before, during and 48 hours after installation.
• Floor must be sound, smooth, dry, clean and free of excessive
  moisture or alkali. Remove dirt, wax, loose paint and all other foreign
  matter that would interfere with a good bond such as curing agents
  and sealers.

INSTALLATION:

• Stir any liquid on the surface into the adhesive.
• Full spread adhesive using recommended trowel.
  Note: Recommended trowel sizes are minimum requirements. Porous
  concrete and some carpet backings may require deeper notches.
  100% transfer of adhesive into the carpet backing must be obtained.
• Install carpet immediately into wet adhesive unless carpet or substrate is nonporous. In this case, wait 10 – 15 minutes before installing carpet.
• Within 60 minutes, cut, fit and reposition as recommended
  by the carpet manufacturer.
• Roll floor in both directions with a 75-100 lb roller and seal seams as
  recommended by the carpet manufacturer. Stiff carpets should be
  rolled again after 2 hours. Restrict heavy traffic over carpet for 24 hours.
• As is customary with normal installation procedures, do not sand, dry
  sweep, dry scrape, drill, saw, beadblast, or mechanically chip or
  pulverize existing resilient flooring, backing, lining felt, or asphalt
  “cutback” adhesives or other adhesives. These products may contain
  asbestos fibers and/or crystalline silica. Avoid creating dust. During
  the installation process, adequate ventilation of the work area should
  be maintained. Persons who are sensitive to odors and/or chemicals
  should avoid the work area. Inhalation of such dust is a cancer and
  respiratory tract hazard. Smoking by individuals exposed to asbestos
  fibers greatly increases the risk of serious bodily harm. See current
  edition of the Resilient Floor Covering Institute’s publication
  “Recommended Work Practices for Removal of Resilient Floor
  Coverings” for instructions on removing all resilient floor
  covering structures.

CLEANUP:

• Wet Adhesive: Clean, white cloth dampened with soapy water.
• Dried Adhesive: Clean, white cloth dampened with mineral spirits; carefully following warnings on container.
• Do not wet wash carpet for 5 days after installation.
• Note: Do not reuse container. Dispose of container and adhesive residue in accordance with federal, state and local waste disposal regulations. Do not flush adhesive down drains.

  VOC content:0 g/L; calculated & reported, SCAQMD 1168

WARNINGS:
Carefully read and follow all cautions and warnings on the product label. Refer to the Material Safety Data Sheet for additional product information.